Panasonic KX-TA/E

...

1. From the back of the phone, set this to Program.
2. Press - * followed by the # key, then enter your system password.
3. Press # # to enter the

   Referencemacro
   Label Programming mode

   .

4. Go to programming code 800, and set each of the settings as shown below. Press  Store and then Next after each entry, in order to move to the next setting:

   SMDR field	Value
   NL-Code	CR+LF
   Baud Rate	9600
   Word Length	8 bits
   Parity	None
   Stop Bit	1 bit

5. Go to programming code 801, and set each of the settings as shown below. Press Store and then Next after each entry, in order to move to the next setting:

   SMDR field	Value
   Page Length	Leave as default
   Skip Perf	Leave as default

6. Go to programming code 802, and set each of the settings as shown below. Press Store and then Next after each entry, in order to move to the next setting:

   SMDR field	Value
   Outgoing	On
   Incoming	On

7. From the back of the phone, set this back to Store.

<a id="Install NetPBX"></a>

...